How to Use JB Weld – 5 Steps of How to Use It

JB Weld is a great product to use when you need to repair something on your car or in your home. It’s easy to use and can be applied in seconds, but there are more effective solutions for some situations.

In this article, we’ll show you how to properly apply JB Weld so that when it cures appropriately, it will hold up against even the harshest elements like heat or water pressure!

How to Use JB Weld

Weld is a two-part epoxy bonding metal, plastic, and glass. It’s an ideal repair solution for the home or office. The high strength of this product means it will fill gaps in most materials and make a strong bond between two surfaces.

JB Weld is great for repairing anything from household items like furniture legs or tools that have broken off at the base of their handles to cars’ bumpers and windshields!

Apply a Thin Layer to the Surface Being Bonded

  • Apply a thin layer of JB Weld to the surface being bonded.
  • Using a paintbrush or cotton swab, apply the JB Weld onto either side of your project. You can also use a leveller to ensure that both sides are perfectly parallel before applying any extra material (see step 3).

Allow JB Weld to Cure

The second step is to allow JB Weld to cure. This will take about 24 hours, so you’ll want to plan and allow yourself some time if you need to use the joint sooner than that.

JB Weld can be used in temperatures as low as 40 degrees Fahrenheit, but it’s best to stay under 200 degrees Fahrenheit (or 93 degrees Celsius). If you decide to work with higher temperatures, ensure your workspace is well-ventilated, and keep an eye out for any signs of burning or smoking when applying pressure on the joint.

Sand and Polish the Area

If the area is sanded, it’s essential to use fine-grit sandpaper. Use water on the surface of your work area and keep it wet as you sand using an orbital sander or power sander.

When you are finished with your sanding, apply some polishing compound – carnauba wax or Griot’s Garage Ultimate Polish Pad – over the scratches that remain to remove them altogether. Work in small sections at a time, so you only push a little pressure into one spot, allowing some time for drying before moving on to another part of your project.

Apply a Second Layer of JB Weld in the Same Manner as Previously Described

Now that you have applied the first layer of JB Weld, it’s time to use a second layer. To do this, follow the same steps as previously described.

However, this time around, allow for an additional 30 minutes before removing from your project. If needed, repeat this process until your desired thickness has been achieved or until you’re satisfied with its strength. Read Also What gas to use for Aluminum MIG welding, What is the best gas for MIG Welding Wild steel?

Allow the Second Layer of JB Weld to Cure Completely, Then Repeat Steps 3 through 5 if Necessary

Once you have applied the first layer, allow it to cure completely before applying a second layer. The second layer should also be used the same way as the first; however, this time, you will want to apply only enough JB Weld so that it does not run out of your hole or crack at its edges.

If this happens, add more Weld and allow it another hour or so for complete curing.


As you can see, JB Weld is a very versatile product that can repair just about any surface. It’s best to practice using it on some scrap wood before attempting to bond it permanently.

This will help ensure that you know how much material is needed, what kind of surface should be prepared, and how much pressure should be applied during the application. Once mastered, you’ll have no problem bonding whatever material your heart desires!

Note: ElectroWeld is reader-supported. If you click a link and buy something we may receive a small commission at no extra cost to you., learn more on disclaimer.

Leave a Comment